Drag Bars for Bobber

     also fit Scouts

These drag bars are available in black. They are a true 1" diameter with the knurls in the correct place. The ends are reduced to 7/8" diameter for the controls and grips. The ends have a 8mm threaded hole to mount the stock mirrors. Just about 33" wide. These bars really look correct on the Bobber. You can still use the stock cables.

Black Drag Bars for Bobber. Part #SctBob-DragBars-B  Price $259.95 plus $24.95 shipping

SPECIAL NOTE:

Since these bars are low and don't rise up. Depending on how you mount the grips and mirrors they may touch the tank if you turn the fork fully. This is not a problem while riding. If they do touch caution is needed when backing up and manuvering in the garage.

Drag Bars with turn signals on ends

These are the same drag bars but are machined to allow you to mount turn signals on the ends. They need to be like the MotoGadget style that expands into a 14mm - 21mm tube. The turn signals are not included. The ends are machined out to a 16 mm hole on each end. The hole reduces to a 1/4' hole and allows you to run the wires to the center of the bars and exit in the middle of the fork.

MBlaze turn signals are now being made with a threaded tube. We can also make the bars accomadate the new style. They also sell a set up for mirrors and turn signals. Just let us know which turn signal you are going to use. Send an email to:

IndianAftermarket@gmail.com

Black drag bars for turn signals

Part# SctDragTurn-Blk   $349.95 plus $19.95 shipping

Chrome drag bars for turn signals

Part# SctDragTurn-Chr   $379.95 plus $19.95 shipping

The turnsignals are made by MotoGadget in Europe. You can buy then from Revzilla in America. Here is a link to the MototGadget site so you can see what they are. Then buy them from a U.S. source.

https://motogadget.com/shop/en/m-blaze-disc.html